- Neck screw broke off in body....BAD!!!
- Collective experience thread: tips and tricks for making the perfect Stratocaster NUT
- wiring humbucker to pot?
- What electronics upgrades for my Strat?
- Help: Tele mid position sounds weak and thin
- 500K Strat Tone Pot?
- My DiMarzio Area loaded strat has a noisy bridge p/u
- Has anyone built a les paul? need your help with drilling holes for pots
- RS Guitarworks Superpots and Treble Bleed?
- Will this fit?
- 70 yr old family spruce tree torn down...
- Norlin LP - Experiment with Tone pot value?
- What household item can I rub on a neck to help fit into tight pocket?
- Wiring help - Tyler and Bill Lawrence (Wilde) pickups
- mini bucker/filter trons into a humbucker slot
- Good Guitar Techs in Shanghai?
- Unusual necks
- How to remove Floyd Rose stud inserts?
- Help me trick out my guitar! advice needed
- Has anybody............?
- Trim pot to control audio taper?
- Repairing a nick
- Volume and Tone pot question
- Tell me about the RS electronics...what's the hype?
- Firebird and Steinberger tuners....WTF?
- log and linear pots
- Refilling and redrilling strap button hole?
- Out of phase--TWICE??
- Dead pickup???
- Help me find this neck!!
- Pickguard screw broke off in body....help!!! (Pic)
- I have a Tele Mod idea!
- Why did Gibson move from ABR to Nashville bridges?
- Volume problem on certain notes
- tall fret problem
- Are PRS 5708 pickups 4 conductor?
- Slider Pots?
- Guitar Tech Near Santa Barbara, CA?
- Just got a gretsch electromatic, mod suggestions?
- Varitone questions
- I'm getting a clicking noise from my bass-- I've eliminated the cable and the amp...
- Strange things after a pot upgrade
- TOO POOR FOR REPAIR! Guitar Sounds distored when it should be Clean...Any ideas???
- How to apply Guitar Grease Graphite paste?
- Where to drill holes for Trem Cover on Strat?
- Has anyone tried the GFS Tele necks?
- Replace a Feiten nut...special nut or standard?
- What's the biggest factor in volume knob sensitivity?
- Soldering problem
- What do you use underneath pickups?
- A couple Strat questions...
- RS Guitarworks MODERN strat kit, brightens up your guitar?
- '90s MIJ Strat - Nut Material?
- 'Pingy' rosewood bridge
- How can I tighten the Jack on my Tokai 335 copy?
- Wraparound tailpiece replacement ideas
- Does anyone have the specs for a gibson sg to build one?
- how to reverse polarity in a strat pickup?
- Brightening a dull sounding guitar via pot values
- Maple fretboard question
- Combining Les Paul and Strat wiring?
- stuck between two players and their truss rod,please advise
- Bigsby Lubrication
- pickups for my epi les paul.
- replacement vol & saddle for strat.
- Black hardware question.
- How do I stop breaking strings?!?
- Tweaking an SG for maxium tone & sustain
- Non-locking Trems and the G String!!!
- Anyone familiar with the older MIJ Strats with System 1 Trems?
- Neck replacement or fret crown?
- Pickup 4 conductor wiring question
- Help with pots for a Gibson
- Tone questions
- Bridge ground wire came off!!!
- Testing out Jerry Donahue Lead Pickup
- Finish on Explorers?
- Just Scored(?) One of These At A Local Guitar Shop. Anyone Got Any Info On This?
- Replacement saddles for tele?
- Pickups too hot - distorting?
- Worst guitar ever - technical reasons?
- Gibson 50's wiring mod on Strat
- Gibson '68 345 Twisted Neck - advice needed.
- Replacement knob for R7 VOS Les Paul Goldtop?
- Any other guitar repair forums?
- G String a little jangly when fretted...
- Loose bushing and stripped screw
- Brian May switching
- Fender Custom Shop 69 and Texas Special wiring
- 5 Way switch wiring gone awry! Help!
- Scalloping frets?
- Getting stickers off of a fretboard?
- Strat with Trem: When string bending the others detune
- PRS with one Duncan...how do I wire it up right?
- Anyone explain magnet flipping to me?
- What happened to my volume pot?
- Checking pot values
- Would someone please explain to me what a 10% taper pot is?
- How do I get rid of the "popping"?
- Pickup experts: from dogear to soapbar?
- Stratocaster Setup possibilities and problems
- Tune-o-matic bridge post movement solutions?
- Jensen Caps
- Correct Control Wire for Les Paul?
- Blue Led wiring?
- 1959 Fender Tele Neck Radius?
- Best way to covering over stop tailpiece holes on my bigsby modified guitar?
- Strat String Height at 12th fret - no capo?
- Tune-O-Matic Collapse
- Need Nashville Guitar Repairman Suggestions
- wiring diagram - dimarzio fast track
- Sharp saddle screws? What to do?
- Reparing ding in the poly finish of a PRS SE?
- strat question about neck relief
- Wiring a shield-painted guit.
- Les Paul wiring or pickup problem
- Humbucker Outputs?
- Why do bridges/strings have to be grounded?
- Hum on neck pickup! HELP!
- Plug & Play wiring for pick ups? Advice please.
- Buzzing Strings Source?
- Gibson S1 wiring
- e and b strings thin out when bending ~ need advice
- Potentiometer-math Newbie question
- Tele Neck Has 1 More Tweak to it
- Mixing a two point fulcrum trem with a locking nut
- Inexpensive humbuckers
- Single coils with too much top end - caps? Pots?
- Converting G&L ASAT Classic to Bluesboy?
- Filing a nut
- Dumb question - changing pickups in my Eastman
- Les Paul - Humming even on clean?
- Tone difference between caps of different values
- Nasty grounding / humming problem
- Using hair ties as strings dampers
- MIM Strat Upgrades - What are the MUST-HAVE's?
- Super tall frets on vintage radius fretboards. Does anyone make...
- what make and model is this piezo bridge?
- Alternate vintage tuner string winding
- Shielding method?
- Strat guys: what is this neck?
- How to mount Dimarzio pickups in LP-style mounting ring?
- Scale length and hollow body guitar question
- Buzz/hum diagnosis/questions on AFRC Strat
- Very basic question about a split humbucker.
- Tone of Graphite nut vs tusq or bone
- tele neck humbuckers
- "Fretting out" question
- What pots and capacitor for a lipstick pickup?
- Two screw Strat trem.. How many springs?
- Blade Texas Standard Wiring problem
- Modified strat wiring
- hand built guitar
- Guitar Nut lube
- Gotoh replacements for Gibson hardware
- Kinmans Buzzing???
- Diagram Like This One For Strat, One Master Volume, One Master Tone???
- Polyester basecoat with nitro-cellulose topcoat - What's the point?
- Mojo pickup cover for a SD '59?
- Need Help with wiring two p90's with 5 way switch
- Nickel sheilding "paint" for cavity???
- Need Wiring diagram for two P90's 2 vol, 2 tones, and a five way switch.
- Grosh EJ Fretting out
- Wiring Humbuckers in parallel or series questions
- klein pickup overload
- Looking for a new soldering gun
- Source for a slotted "A Width" nut?
- Condenser for "out-of-phase" tone
- Pickguard design from scratch
- 6105 frets ...too tall?
- Sitar G string
- Ibanez Artcore bridge problem
- Intonation question . . .
- anyone ever order strat pickups from guitarfetish?
- Should I treat a bare rosewood fingerboard?
- Danelectro Upgrade Project
- Setting up a guitar for E flat tuning
- Can pickup height affect intonation?
- GFS vs. DragonFire vs. GuitarHeads
- The Sound of Capacitors
- Fender Telecaster Pickguard Screws?
- Gibson SG Special > staying in tune ?
- Finding a 6 string banjo bridge..??
- Gibson F hole question?????
- refinishing a maple/rosewood neck to a solid black help
- Adding a "bright cap" to a pickup?
- Measure value of installed volume pot?
- is this a real Robin Ranger ?
- repro parts for vintage silvertone / danelectro
- Help Me Identify This Single Coil Pickup Please
- Help Me Identify This Single Coil Pickup Please
- partscaster question
- Anyone know if this pot works well for a strat?
- How to measure pot values?
- Help Wiring Tele With Neck Humbucker (coil tap)....
- P-90s in Les Paul too bright -- fixes?
- Anyone ever put a non-RWRP pup in the middle?
- I want a thinner neck on my mim strat. Any ideas?
- Push/pull question
- Telecaster Standard Vintage Wiring?
- Headstock Pull on my Silvertone! Help!
- Who makes such pickups?
- Tele neck pickup covers.
- Weird Pulsing - Please Help Me!
- Fender Strings now Made in USA
- Problem with Tele neck.
- Switched pups in my tele, now I got a problem
- Humbucker question
- re-organizing workshop - any tips?
- Help on how to remove prs mccarty tuners
- Les Paul humming - need advice
- Pickup switch problem?
- Please explain how these switches work...
- Which Caps for a Gibson ES335?
- modifying a neck
- Complex wiring question! Is it possible?
- About to shim a neck- what to use?
- Which pots for '95 Gibson LP standard?
- RS pots not living up to claims---did I do something wrong?
- 1969 Gibson PU - need a match made by?
- Broken Acoustic guitar (bridge trouble)
- Old style PRS tuning cams
- Sanding sealer for Tele build - what to use?
- 1973 Strat Pickups
- CS336 Not Staying in Tune
- Guitar Engineering 101 Questions
- mid 60s 335 neck profiles, nut widths
- Where do you get parts for your Partscasters?
- I soldered my first pickup today.
- Dimarzio new Paf vs old Paf
- What's the purpose of slanted pickups?
- Preventing grounding 'pops' on a Strat
- New Gibson strap button screws are different sizes...why?
- Any place that sells a toolkit for guitar?
- Glues: Which to use for dowelling?
- Question about the "quack"
- DeArmond Goldfoil Questions
- Cleaning Strat bridge saddles
- Gluing Nut
- Firebird tuners???
- Pickguard scratching sounds??
- possible to get tele config on strat style guitar?
- Best way to wire in middle pup on tele
- 50's wiring
- Ibanez PGM-30 Details?
- Wiring three pickups
- Strat singles - mixing magnet types - advice sought
- Over-Beveled Fret Ends - What are my options?
- Ever done a guitar with NO finish on the wood?
- PRS Starla - Which Tonepro bridge replacement?