- Which Bigsby for Les Paul Standard
- 500k pots are way different than 250k!
- Minihumbucker and FilterTron size PUPs
- Strat - wiring neck and bridge tone together
- Taking off poly finish on LP neck? Relic?
- Direction of split coil pup
- 500K or 250K for a P90 McCarty?
- Best humbucker-sized single coil for rock
- Guess I'm a doofus...
- Plastic Rhythm/Treble thing???
- getting more sustain from a 1985 Kramer Baretta
- do higher value pots change the volume control's use.
- Cutting Nut Slots
- Really *good* push-pull pots?
- Building a parts tele..which parts?
- Don't laugh...IS Krylon OK for this?
- wiring upgrade for LP help
- What kinda switch in the Epi DOT
- I learned wrong as a young man (stringing)
- Ric 3001 question
- Strat Piezo Bridge vs Callaham
- Question about soldering technique
- Help?? PU Wolfetone, Manluis and SD Reccomendations
- Removing Pick-up Screws
- Earvana Nut - Where and How Much?
- Tremolo dive=thick E goes one semitone sharp...
- Felt Strap Button Pads
- Nashville Tune-O-matic vs ABR-1 Tune-O-matic
- Microphonic Tele Bridge Problem
- Wilkinson Roller Nut Problem
- Strat wiring (cap on 1st tone pot) question
- Strat Bzzzzzzzzzz Question...
- Which nickel covered HB should..
- Refinishing a Strat
- Mystery snap, crackle, and pop in guitar electronics.
- guitar out of tune-ness question
- Installed new pickups, bridge help
- Help With Getting Solder Off Pots
- Guitar Repair Question, Please Help Luthiers!
- Strat with no tone cap- what happens to the tone?
- ultimate tone breakthrough, for luthiers only.
- Polishing nickle-plated parts??
- SG 61RI - new pickups
- Tuning issues with my new Suhr
- Humbucking pickup noise
- noisy guitar
- Opinions on a Gibson Nighthawk Please?
- What are these pickups?
- Les Paul Clicking! What gives!?!?!
- How much wood do you need for a LP top?
- Wet sanding & Drill Holes: How do you deal with it?
- looking for help on upgrading pups/electronics
- Series/Parallel/split - what does it mean?
- Single Coil Hum - OUT OF CONTROL!!!
- One strat pickup notably darker than the others.
- Does anyone know of a good guitar tech in SoCal?
- Trying to avoid hum...
- Strobe tuner to set intonation ?
- Fretboard inlays effect on sound
- High end cable
- Pickup Wiring Question
- No sound in number four position on my Strat!
- What is the correct pickup placement for a LP Junior Neck pup?
- Looking for good Guitar tech in Tampa, St. Pete, Clearwater area
- newbie intro to soldering?
- Putting a single coil in a humbucker slot
- I need help picking a Humbucker set.
- I've got a weird one....
- Pickup resistance
- Derek Trucks' slide guitar action....?????
- Do blues players wear frets faster?
- Acrylic as a body material.
- please explain 50's wiring
- Bill Lawrence Q Filter
- ABR-1 Tune-o-matic Replacement
- RS/Jensen Guitar Caps
- Oil Fretboard or not?
- Need some help: how to go about darkening a light rosewood fretboard?
- my strat neck isn't a really tight fit....
- Glendale Tele Bridge Placement Help!
- Finish stripper?
- Good luthier NY, NJ for refretting help
- ONE damn string buzzing - what to do?
- Bone nut + ledded sheet = sustain !?
- faulty CTS pots?
- Bigsby leaves holes that show on Les Paul?
- Discovery - Bolt-on neck pocket fix
- Is there a simple way of changing strings on a bigsby that I'm missing
- Truss Rod Problem
- "50's" les paul wiring debunked?
- pick up cover 50mm or 52mm?
- Bad ground or broken pots?
- Wiring Problem
- Out of Phase Wiring--T Bone Style
- Anyone "buff out" their Gibson faded guitars?
- Mighty Mite necks: Do they suck?
- Replacement p'ups for MIJ Strat
- Recommended Guitar Tools?
- I need to raise my nut a little (how to?)
- Intonation - How close is close enough?
- Trouble rewiring guitar ... no sound... troubleshooting
- Further delve into the realms of Guitar Intonation, in-depth post.
- Decent stacked Vol/Tone or Tone/Tone pots?
- vintage frets??Like or dislike?
- Solid-body electric's acoustic sound
- Gibson Les Paul Tuning Problems
- PLEK and guitar setup
- Does aluminum foil work for guitar shielding?
- Basic Refinishing Questions
- P-94, Phat Cat, or Z-90?
- Vintage fret question
- wall haging long-term effects
- Help Please!! Pickups' - How to replace ?
- what pup to replace a Duncan JB in an LP?
- Need help wiring Les Paul
- rs kits- are they hard to install
- Strat Capacitor??? <<<<RECOMENDATIONS>>>>
- Nut file sizes
- Ding in the side of my maple neck
- Dead Spot?
- Telecaster Humbucker w/ Single Coil wiring question
- replacement bridge for ASAT Classic Tribute
- 3 Way Mini-Toggle???
- Fender Bass MIA or MIM...?
- Can BOTH p'ups have a split/tap?
- Lightening an LP Custom
- abr1 saddles - cut new notches?
- Dimarzio PAF Classics... Anyone with experience?
- Bolt on neck guitar Questions
- 2 conductor wiring help/humbuckers
- 2 P90's Equipped Guitar
- polishing frets with micromesh
- Strat replacement pups...which do you prefer?
- which tuners UK?
- Acoustically insulating pickups from guitar top?
- These pickups turned right direction? (G&L)
- Help with "surgury" on Epi 335 Studio please?
- Guitar hardware
- Can a Dremel do a good job cutting...
- I wanna put a pre-amp bypass switch in my Clapton strat. Help electronics gurus!
- Removing nitro lacquer on neck,play better?
- Trying to Solve a Tele Bridge Problem
- No Hum Cancelling w/ my new strat pu's!!
- Frozen Sperzel Pin
- Guitar/amp grounding ...
- Help-DYI:Relic-ing a Strat neck
- EJ Strat neck pickup quandry, opinions?
- 7.25" radius necks and fretting out at 11th fret
- shimming a neck
- EZ-LOK tuners
- I need a soldering gun!
- I can't see the side dots, what to do?
- luthier's, repair people! fret leveling/crowning ques.
- Strat wiring problem: Neck / Middle not working
- "Blemished" new guitars, with their warrantees
- tele static or grounding problem
- Strat tremolo bar angle
- Downward Pressure Against Nut
- Telecaster with Humbucker... what pot value?
- I need a pickup recommendation!
- Strat frusterations! Suggestions?
- Any electronics gurus out there?
- polishing *stainless* frets
- Vinyl or waterslide?
- Heritage Tonepros
- Re: Melvyn Hiscock's 'Make your own Electric Guitar'
- stuck screws
- Van Zandt reading 19.06K??
- Stripped pickguard screws
- Replacing 72 Tele HB
- Question about refretting a Strat neck??
- Are the Gibson Fades the same as....
- Which Wilkinson Trem?
- '57 Gold Top RI plays sharp on first 2-3 frets
- Dual ganged 50k/250k pot. Does this pot exist? Can I make it?
- Good refreting in LA area??? Help
- Could you measure your wilkinson vintage trem?
- Dead Volume Pot
- earvanna compensated nut?
- Fixing a sticky neck...
- what's the trick for wiring this right?
- Tin Can Pickguard?
- Knobs for EMG pots?
- PAF du Jour?
- Bridge Pickup Placement "Sweet Spot"
- Exposed windings
- Possible stupid question. Buzzy electric sound...
- Squier P-bass
- Les Paul tail piece question
- Stratoholics.....need Help With A Question
- Problem with tuners...
- Tone control taper
- Shortening pickup wires -- better tone?
- Installing Humbucker Question- ohms
- Hagstrom pickups and pots
- recommendation for nut files? Brand? Source?
- Changing ES335 tailpiece to a lightweight?
- what is a "plek" setup please?
- Grounding Buzz on a Gibson ES347
- Pimp my strat
- General consensus on 335 Crack.split???
- Too-harsh Tele - What's that noise?
- Neck Construction
- Demeter Onboard Midboost Owners I Need Your Help!
- Any luck tinting Crazy Glue for minor finish repairs?
- How to remove blocked knobs
- Pot shaft length for Epi LP upgrade?
- Best action for ES-335?
- RS superpots
- Stratocaster Sustain Problem...
- Low Tuning Setup Help
- Bolt-on neck tap inserts - so far, so good.
- What do I need for my parts-o-caster?
- truss rod adjustment & strings
- Oddball wiring question
- Just got setup, now fret buzz is back?
- New Pups from the Fetish...
- What capacitor for less high-end roll off?
- Get rid of the tone knob?
- Fret indicator problem
- Question on Pickups for a Strat
- where to find parts, I'm ready to start building my own
- Blend pot woes....
- bass pickup problem
- best vol pot value for H-S-S in a strat
- Pickup soldering question
- Odd behaviour from tone pot
- calibrating calipers
- blend pots
- RS Guitarworks--who's upgraded??
- First Fret Buzz with 6100
- Resonance and finish
- Epi Dot Setup question...G string is sharp
- Help! Pickup install issues...
- What's the best bridge hardware for a 335?
- So if the feel of a Strat relies on the nut height...
- Tools needed for cutting a nut and doing a setup?
- Warmoth truss rods...
- how to change pickups on a ES-335??
- Source for 500k No Load Pots ?
- Questions about/help with low output strat pickups
- Headless String Adapter
- Graph Tech Ghost system
- Grounding issue in Fender strat
- Weird Fretting-Out Problem
- Smoke Smell
- You guys have a good solution to stiff CTS Super Pot?
- Acme "blender" pot different from "no-load"?
- Drilling Holes in Nitro?!
- Copper Shield reduce Strat Hum ?