ext. cab suggestions

[srb531]

to sit under my deluxe reverb,1-12, 2-12, 2-10, or 1-15 ?, prefer solid pine for lighter weight, must be a little wider then the DR width of 25" any ideas on this .thanks

[major-minor]

I'm watching this thread too.

[335guy]

The Avatar Traditional can be covered to look very muck like your DR. At 28.5" wide, it's a little wider, leaving 1.75" on each side of your DR. You would need to use 16 ohm speakers wired in parallel for an 8 ohm load. Combined with your internal speaker, the amp would see a four ohm load. Which is ok for a DR

[Dawg76]

+1 for the Avatar Traditional. My silverface Princeton Reverb and Marshall Haze 15 head take turns on it. Well-built and reasonably priced. They're made of baltic birch, so I'm not sure about the weight.