danieldroukas
04-09-2007, 04:25 PM
I've got a friend's JCM 2000 TSL footpedal here that isn't working properly. The footswitch connects to the amp via a 6-pin DIN connector, but in checking for continuity between the pins and the wires coming out of the other end of the cable (to the footswitch), only three maintain continuity. I figure the DIN connector has lost a few connections and perhaps needs replacing. I've never bought a DIN before, so I'm wondering if anyone knows if the following Neutrik would work:
http://www.mouser.com/search/ProductDetail.aspx?R=NC6MXXvirtualkey56810000virtu alkey568-NC6MXX
Oh, and if it interests you, only pins 2, 3, and 4 maintain continuity from one end of the cable to the other. I can't hack off the existing DIN yet to check for wire breaks since it's molded onto the cable itself.
http://www.mouser.com/search/ProductDetail.aspx?R=NC6MXXvirtualkey56810000virtu alkey568-NC6MXX
Oh, and if it interests you, only pins 2, 3, and 4 maintain continuity from one end of the cable to the other. I can't hack off the existing DIN yet to check for wire breaks since it's molded onto the cable itself.