Custom Cable Needed

[EdM]

I need a custom cable made to use my Rocktron Replifex to switch channels on my Rivera K100. The Rocktron uses a TRS cable and the footswitch for the Rivera is an 8 PIN DIN. Does anyone know a company that can build a cable such as this? I have been having some difficulty finding a company that will do this.

Thanks!

[Blue Strat]

You would need specs for the interface at each end in order for someone to build this. It might involve more than just a cable.

[EdM]

I do have the specs for the pins on the amp switching cable and for the tip ring sleve on the Replifex. I believe that would be all that is needed. Do you know of someone who can help?

[Brion]

Check with axess electronics. They may be a ble to help.

[EdM]

Funny you should mention them. I tried Mario there and he responded that he no longer manuractures cables to other companies switching products. Any other thoughts?

[Fuchsaudio]

http://www.rjmmusic.com/

Talk w/ Ron.............he's the man.

[teleamp]

I'd give Lavaman a shot.

MikeY

[jamison162]

If all you want to do is channel switch, just do a simple mod that would involve drilling and adding a standard 1/4" mono jack to the back of your amp chasis. Tap the ground and switch leg from your 8 pin at the board...you said you have the pin specs for that connector right?

You could then use the other functions along with your stock footswitch. Otherwise, I think you would be abandoning all other switching functions by going 8 pin to TS/TRS.

[EdM]

Thanks Fuchsaudio! Ron is indeed the man. He is making the cable for me. I will be able to swich channels and operate one of the boosts which is exactly what I am looking for. No more tap dancing for me!