Behringer repair parts ????

[pepi]

Trying to help out a local kid on a Behringer Vampire amplifier. He needs a new selector switch for the amp models. Any of you guys ever found a dealer that can order parts for these cheap amps

[El Caballo]

I'm pretty sure they use ALPS encoders. Open it up and you can probably find a part number on it...if not, you can probably just measure the shaft length and find the right encoder in Mouser or Digikey. It should cost about $2. Can you solder and use a multimeter?

For that matter, you might get lucky, the problem is just cracked solder joints, and just re-tinning the contacts will fix it.

[trdlasvegas]

http://dbmproaudio.com/behringer.html

-Tony

[pepi]

I'm pretty sure they use ALPS encoders. Open it up and you can probably find a part number on it...if not, you can probably just measure the shaft length and find the right encoder in Mouser or Digikey. It should cost about $2. Can you solder and use a multimeter?

For that matter, you might get lucky, the problem is just cracked solder joints, and just re-tinning the contacts will fix it.

I found an old junk Vamp2 and pulled the encoder out of it. Amp works like new again :dude