71Champ three prong

[angelodp]

http://i260.photobucket.com/albums/ii9/angelodp1/Champint.jpg

This Champ has an INT tranny.... is this wired correctly ??

Any help greatly appreciated

[RL in Fla]

Can't address the INT issue , but
Safety-wise , No . That config is switching the white (neutral) , and the black is always "on" (referenced to chassis ground)
as long as the fuse is intact and it's plugged in .

A short to referenced chassis ground will keep on truckin' (frying) until the fuse blows ,
even if the switch is off .The switch should be on the incoming black/then to the fuse .

Easy fix , unsolder the wires to the switch , solder all together/insulate (heat shrink)
Move the incoming black from fuse -> switch , run another wire from switch to fuse where black goes now .

Ideally the fuse should be between the incoming wire and the switch , then wires from switch-> tranny .

In-> fuse , fuse-> switch , switch -> tranny (stripes)

If in doubt hit up a tech , that's a 15 minute no-brainer if you walk in with the chassis ;)