PDA

View Full Version : pot value for line 6 expression pedal?


chrisross
10-06-2011, 01:57 PM
25k right?

Warlock279
10-06-2011, 05:50 PM
Actually I believe its 10k.

Here's a couple links on the Line6 forums I had bookmarked that have some information about it.

Show off your M9/M13 Board (http://line6.com/support/message/308289#308289)

Momentary Expression-FootSwitch for M9 (http://line6.com/support/message/234191#234191)

I'm sure you could dig around there and turn up some more info.

orogeny
10-06-2011, 06:02 PM
i don't know. . .

depends on the pot. . .

we talking jamaican? thai? hydroponic?

i'd trade like a quarter ounce of schwag for one. . .

or

. . . . were you talking electronic stuff?

:BluesBros

8len8
10-06-2011, 07:56 PM
I just measured mine - 20K.

chops612
10-06-2011, 10:23 PM
The Line 6 expressions use 10K Linear pots. The reason you read 20K is because that pedal uses a dual ganged 20K pot wired in parallel giving you.... 10K of resistance.

kwood86
10-06-2011, 10:49 PM
i use ernie ball 25k active volume pedals for my two expression pedals on my M13 and they work great

chrisross
10-07-2011, 10:33 AM
Ok, I'm seeming to find 10k as well. I know the Ernie Ball's work, but I think the standard factory expression pedal is 10.

I'm pretty sure line 6 stuff uses a mono cable to their expression pedals instead of TRS like the other guys, so how would I wire the pot to the jack? Gut shots of a Line 6 expression pedal, factory or DIY, would be great

chops612
10-07-2011, 12:24 PM
Correct... For Line 6 they ONLY use a variable resistor setup so only need a mono (TS) cable. While the 25K will work with some of the models the HD stuff definitely wants to only see 10K. The fact that the EB are audio taper and not linear taper help out the fact that the value is higher as you can get 0-10K in about 75% of the throw. The 11-25K doesn't do anything else. But the correct response that works best is a linear 10K, which gives you smooth 0-100% control.

Wiring wise tip goes to wiper and lug 1 (normally ground) goes to sleeve. If using a 25K EB just simply plug a normal cable into the OUT and you'll have it.

drbob1
10-07-2011, 01:46 PM
I'm sort of keeping a list of how manufacturers are implementing EPs. Good to know. The only other things I'm sure are variable resistance are the SIB Echodrive and the old rackmount Digitech Analog Delay.

chops612
10-07-2011, 03:26 PM
Eventide pedals as well.... Stay tuned with Thru-Tone... Good things comin... ;)