|
#16
08-21-2009, 08:45 AM
|
|||
|
|||
|
You are going across both wires. forgo the wires and go from either side of the 470 ohm resistor ( the blue one in the pic) to ground. It will be close enough. Be very careful and use an alligator clip on the ground side.
|
|
#17
08-21-2009, 08:50 AM
|
|||
|
|||
|
You're in the right area...
You have it right, area wise. You might want to read your DMM's instruction manual to see if there are any other options for measuring DC voltage.
Mike
__________________
Mike "Yes...I was having a cup of tea with Mr. Roccoco here, when suddenly this madman burst through the door. Honking wildly, at the last possible second, he stopped on a dime. Unfortunately, the dime was in Mr. Roccoco's pocket..." . Good Deals here.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
