|
#1
12-23-2010, 06:58 AM
|
|||
|
|||
|
How do you install Battery Kill Switch in Wah?
I am trying to figure out how to install a simple battery on/off switch into my wah pedal and have had no luck finding anything on what I would assume is a simple mod. Can anyone help?
__________________
Try, Try Again, even if you don't know why you're trying, keep trying anyway... Billy Joe Shaver 
|
|
#2
12-23-2010, 08:20 AM
|
|||
|
|||
|
Not sure, but Dan aka this1smyne is installing a mini-toggle on my boost pedal to kill the input signal (and thus preserve battery life).
__________________
Squier Thinline--Bad Monkey/Route 66--Phase90--DL4--Pathfinder 15R Good deals: a bunch of people............thanks dudes!
|
|
#3
12-23-2010, 02:52 PM
|
|||
|
|||
|
I added a 9V adapter jack and wired it the normal way. If you run on battery and push a 2.1mm plug it kills the battery feed. Alternately, there's a lot of room under the treadle. You could get a mini SPDT with a short bat handle and put it somewhere accessible.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
