|
#1
03-21-2011, 07:20 PM
|
|||
|
|||
|
Mixing Sovtek 6L6 types?
I just had my Sovtek Mig 100 head re-tubed, and I noticed that the shop installed two Sovtek 6L6GB's and two 6L6WXT+ tubes. I've been reading that these tubes aren't actually equivalent, is this true? Or assuming they have been biased correctly should it not be a problem? I haven't actually had a chance to fire the amp up yet, it would be good to know before I crank the volume and something bad happens. Thanks for the help.
|
|
#2
03-21-2011, 07:42 PM
|
|||
|
|||
|
Its not a problem to mix power tubes types. That said Im not quite sure of the Sovtek 6L6GB. That is to say if its rated at 30 watts like a 6l6GC. Bob
__________________
"Reality is an illusion albeit a very persistant one " Albert Einstein Was I crazy? I began to wonder, for such an appalling lack of perspective seemed near being just that.
|
|
#3
03-21-2011, 07:50 PM
|
|||
|
|||
|
As long as they bias similarly (are somewhat matched) and the max plate voltage is in range it's all good.
__________________
Mike K KCA NOS & NEW Production Tubes & Amp Repair/Modifications The World's largest selection of Guitar Amp Tubes http://www.kcanostubes.com
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
