-
-
Samr replied to the thread Tell me something bad about the Truetone CS12 power supply ???.I've had my CS12 for 4 years with no problems, but it was found dead 10 minutes ago. Cause of death unknown. Not dropped or exposed to... -
Samr replied to the thread Namm 2020: Vht Does Dumble.Nice! The knobs! Where do I get the knobs?!
-
It's a killer unique amp. Built well, low noise, loud A F, inexpensive and ticked all boxes for me except the loop for me.
-
You do realize that a buffered loop requires actual circuitry, right? It's not a personal judgement thing. A buffered loop does 2...
-
Samr replied to the thread Namm 2020: Vht Does Dumble.Good/bad/tonesuck really depends on the ear of the beholder. Not everyone can discern tone suck created by varying degrees of...
-
Samr replied to the thread Namm 2020: Vht Does Dumble.You are correct.
-
That is a big surprise. [Edit: I just looked at the VHT website. I really, really don't think that loop is buffered. Not tube-buffered...
-
Samr replied to the thread Namm 2020: Vht Does Dumble.Sorry, but its not "fully buffered". The send is not buffered, which causes tone suck in many cases, especially with loops that run all...
-
Samr replied to the thread NPD: Dunlop Crybaby CM95 Clyde McCoy.I'm consulting a friend who builds pedals and does warrany work on amps, but the purple wire makes me think hardwired buffered bypass...
-
Samr replied to the thread NPD: Dunlop Crybaby CM95 Clyde McCoy.If you get a chance, a pic might help. I know they still call bypass method "hardwire" in the manual. The fact that they haven't...
-
Samr replied to the thread NPD: Dunlop Crybaby CM95 Clyde McCoy.I realize its 6 years later, but did the TB question ever get resolved? The manual definitely lists the bypass method as "HARDWIRED". I...
-
Samr replied to the thread VHT Chromeback speaker opinions?.Try your 8 ohm speakers. It'll be fine if you just switch it to 8 ohm on back of the amp. There's a switch for that.
-
-
Samr replied to the thread Signal tap question for Behringer XR18.I'm pretty sure the first tap after EQ is "post EQ" (duh lol ;)) & first tap after Dynamics is "pre-fader", based on my own usage. I...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
