Thank you. I don't have a loop, but I could probably connect it at the power amp.
If I understand you correctly, the center tap would be connected to the positive of the series caps? (70 @ 350 in series)
Thanks, I'll give it a try. Mainly wanted to know if it's way off base in terms of what type of signal is going into the amp.
I have a Vox Adio Air GT amp. I love it, but it's a little lacking in volume sometimes.
Is it possible to use the headphone jack to send a signal...
That cracked me up!
I said "until your ear is attuned".
I've had the same experience.
Very eloquent, however, my ability to get an amp to a more pleasing level has nothing to do with imaginary hopes.
Essentially, you're saying I...
I like the 225 Orange caps, not so much the 715's. They are fine, just not what I like. I've been using Sozo Blue caps with good result.
Eminence 1058, by all means! Seriously underrated.
Thank you all for getting me through this.
Interesting, I think sag sounds more appealing. Thanks Tony
I got nothin, but they look substantial!
Good luck with the build.
Ahh, right! Thanks.
Thanks, I kind of thought it was unnecessary, but wasn't sure.
This is the approach I'm using. I prefer the large iron, especially the output.
I'll figure out the mounting.
Budget constraints or I would buy a Super Reverb.
I got it figured out with the 3 amp transformer
I'm going with 10k 2 watt
Yes, this is the approach I'm using.
I'll be trying different speaker combinations, probably a 12 with multiple 10s.
That combination has worked...
Could you recommend a value/wattage for the bleeder resistor? Thank you.
Thank you pdf64, this way I can avoid going the sag resistor or dual rectifier route. I may try the sag resistor just to get first hand experience.
Thank you, this is very helpful.
Essentially to soften the amp, make it lower wattage, use different rectifiers for different effects., such as tighten up with a 5AR4,...
I just ordered some 150 and 200 ohm 25 watt resistors to try the sag mod.
Could you give me a value and wattage guess for plate resistors? I'm...