Separate names with a comma.
I had a 2210 come in recently with the same problem. The chip is a transistor array and is obsolete. It's a common failure in this design.
Channel switching in the 2210 is done with an IC that is really just a transistor array. They are prone to failure and this could produce the...
Replacement impedance selector
Disclaimer: I design, build, and...
Can't read the serial number too well, but the "N" at the end indicates a manufacture date of 1981
Moves my 50 and 100w heads
And 4x12 cab, no problem
Look in Control Panel "power options" and check the battery settings there..
Have you tried calling?
Lakewood, Colorado 80226
Check out the Soldano SLO-100. Parallel filaments, and screens
Thanks for the kind words Shooto!
Glad it's working well for you.
Here are a couple of links to pictures of the amp I lighted with a CCFL
I installed a CCFL in a SLOClone head cab. Despite the amazing amount of gain on tap, the amp remained quiet (as quiet as any high gainer gets)....
Inductors actually oppose any change in current. Capacitors tend to oppose any change in voltage.
Both capacitors and inductors can store...
Yes, your drawing is correct.
If you are using an ungrounded (cliff type) jack, the "common" connection also needs to go to ground
I ordered a cap set last month for a JCM800 that I'm building and got the same run around. I complained via email and was chastized for not...
This has been posted before but it's a great example of incredibly bad workmanship.
They are using 3- 1n4007s in series since the flyback pulse from the OT can exceed 2Kv. You can substitute a single 3Kv diode (Vishay PN...
I currently own two BV-60 2x12 combos. Both were purchased used.
They sound the same...Killer. I've re-tubed them and that's it.
For a "great...
Mike is the real deal. Don't waste your time with unknowns
I've built one.
I started with a Weber 5F2A kit and built it into the Two Stroke. Well, a "One Stroke" really. Instead of running parallel 6v6s...
Do you have a link to the "technical discussion" forum?
Ooops double post
Do you have a link to the technical discussion forum?
Looks like it. Thanks Trout!
Just paid them a visit and it looks like the site is off the air?
Anybody know what's up?
There have been various mods discussed on other forums in the past.
Check out this thread:...