It seems if you dial-in your sound using the bands PA and have monitors/in-ears, no more backline. No point of trying to find FRFRs or other amps, right? Just headphones or monitors for home practice.
Just sent back the K10.2. It reset at practice and stopped working at home. After powering on and off, it started working again. It had the latest firmware update. I had my output set to about 11 O'clock I wasn't overdriving the input.
Great sounding speaker for modeling, but their product is...
Hey everyone,
I was playing my JCM 2555 and the bass knob would barely turn, and then broke off. Anyone know what potentiometer is the correct replacement part? I think it is a 1M pot from the schematic but I can find the replacement part. Help, please.
DEFAULT The basic voicing of the loudspeaker
LIVE For live sound reinforcement and vocal clarity
LIVE BRIGHT Similar to LIVE with some high-frequency boost to balance the sub
DANCE Low and high frequency emphasis STAGE MONITOR 1 For most stage monitor uses, reduces excessive bass build-up on...
I have a ton of gear and was not sure what to take to the studio to finish an album. I have the powered rack version and really just picked a preset, turned off the delay and played my two solos. It took about 7 takes total for both. It was so easy. No mics, no outboard efx. I touched nothing...
As much as I love gigging with a 4x12, it tends to be to big and cumbersome on stage. What is a decent 2x12 for gigging? Will be used with a Marshall head and a few pedals.
I have seen a bunch of threads, and I'm just as guilty, of giving negative feedback on a particular amp or guitar. I think guitar and amp builders should be able to give feedback on the skill set of the people giving their opinions. And we can use skilled people such as Peter Thorn (sorry to...
It is to replace my tube half stack. Most places we play are small so we don't normally have the drums, bass and guitar go thru the PA. Just keys and vocals. So for my self and audience to hear my guitar.
I need a quality powered speaker that sounds great and can handle 25 gigs a year. Using Pod Go and HX Stomp. Not going to mic it or run it thru the band PA. I have a loud drummer and need to keep up with him. What are you using live with your band?
Life is good except for channel 3 LOL. Channels 1 and 2 work great. Plugged into the efx return and everything works. Only channel 3 has the problem. Any other ideas?
Hello Everyone,
I have an EVH 5150 III 100 Watt Head and channel 3 has lost most of its volume. Channel's 1 & 2 work fine. I have swapped V4, V5 & V6 pre-amp tubes but the problem still occurs. The volume did come back for about 10 minutes but no where close to channel's 1 & 2 and dropped back...
Hello Everyone,
I recently changed the tuning on my guitar from standard to drop C. Every time I use the d-tuna all the strings go out of tune by a 1/4 step, some up and some down. The whammy bar is tight against the body and the strings are fairly new. Any suggestions on how to get the tuning...
Hello All,
I have a small pedal board I use for my acoustic gigs and I want to add a more realistic pedal and amp tones. The Zoom is great for what it does but the amp sims miss the mark. I don't have a lot space on my board. I will be using a clean tone and a high gain, rolling back the guitar...
Thanks everyone. I will do some research on your recommendations and let you know what pedal I went with. Thanks for taking the time to share your thoughts and ideas.
I perform solo acoustic and I'm looking for a pedal that will make my guitar sound like a bass guitar. I use a looper and beatbox for some of my songs. Using a bass emulation pedal would add a fuller sound to my performance. What pedals should I be looking at?
Messing about with a new patch from the Lars Luettge Rig Pack. Very dynamic sound. Ignore the flubs. I spent all day just figuring out how to use Sonar Platinum and the new interface.
https://www.reverbnation.com/markgearo/song/28747160-1-minute-rock
Which two knobs are missing? So the Kemper rack with separate power amp allows for more flexibility? I have been going thru the Kemper forum and toaster seem out of place a bit on cabs where the rack sits nicely.
Thanks for the feedback. It seem the rack mount head is easier to manage than the toaster. Add a rack power amp and power strip any passive cab would work. Any recommendations on getting the Kemper with the built in power amp?