amplifire EQ help

massless

Member
Messages
261
Need some advise on the best parametric EQ mode and setting to give a smooth lowpass for taming top end on patches? What ever i try seems to either have little effect or adds emphasis at the rolloff point.

Ditto with a highpass to tame the bottom end.

When i try extreme settings such as full cut of the top end above say 250hz i can still hear signal above the roll off point, almost like theres the full signal still present underneath.
 

TDL

Member
Messages
52
Are you using the "1" versions of the high and low pass filters? or, if you like better the "2" versions, is the Q > 0,7?
 

rcl

Member
Messages
1,768
Maybe go with a shelf instead? Drop pre-eq to taste, freq .32, Q .7 lowcut-again season to taste-45 or so
 

massless

Member
Messages
261
To clarify, I've had my AF swapped out under warranty for another reason (very good customer support BTW), and the new AF works perfectly. The EQ now makes sense and works like I expect parametric EQs to work. The old unit did not... Weird. Wish I had both side by side to A/B so I could confirm that's the case and not that I'm going insane.
 




Trending Topics

Top