Connecting a Second row of pedals on Pt. Jr

Discussion in 'Effects, Pedals, Strings & Things' started by toast487, Feb 19, 2012.

  1. toast487

    toast487 Member

    Messages:
    268
    Joined:
    Feb 12, 2011
    Can someone provide some tips on the best way to link the back row of pedals on a PT. JR. to the front row. I'm unsure of how to measure the length of cable I need and the best way to run it along the board. Thanks!
     
  2. Vishnu

    Vishnu Member

    Messages:
    5,816
    Joined:
    Sep 9, 2007
    Location:
    Scotland
    pedals as always, right to left, as on floor......start bottom right,connect the last pedal on the bottom left to upper right pedal input and carry on right to left again .........last pedal upper left is your output to amp

    bottom left to top right will need a longer cable than the normal 6"
     
  3. jnepo1

    jnepo1 Silver Supporting Member

    Messages:
    13,217
    Joined:
    Oct 23, 2009
    Location:
    Sutton, MA
    From the last pedal on the first row, plug in a cable w/the plug of your choice and run it to the next pedal however you intend to run the cable. The other end of the cable, measure it from where the cable goes to the jack of the second row pedal, that is usually the solder point of the plug you will use to connect. From there just measure that length and build that cable or order that length cable, whichever way you decide soldered or solderless patch cables.
     

Share This Page