Degrading a line 6 m9 loop

Discussion in 'Gear Demo Videos & Sound Clips Archive' started by mwvm, Feb 15, 2012.

  1. mwvm

    mwvm Member

    Feb 14, 2012

    i mentioned earlier in another thread about degrading a loop using the m9... the vid shows this...well, my knee and some knob twisting...

    but basically all i'm doing is switching the loop from post fx to pre fx... tweaking the levels and the loop eq (hpf/lpf) - then i'm putting the loop through 2 delays... a lo-fi delay 20ms dt zero feedback and a tube echo same settings and tweaking the mix on them both...

    hope this shows does the job for curious folk

    also, one important factor..always turn off the noise suppressor

Share This Page