Digi 002 Help

Discussion in 'Recording/Live Sound' started by testing1two, Aug 29, 2008.

  1. testing1two

    testing1two Gold Supporting Member

    Messages:
    1,741
    Joined:
    Mar 26, 2008
    Location:
    Southern California
    Does anyone remember how to reset the eprom in a Digi 002 console? As I recall, it's a key combination that you hold down during power up but I can't remember what it is and I'll be damned if I'm going to pay Digi $3 a minute for phone support without a happy ending!
     
  2. jumpnblues

    jumpnblues Member

    Messages:
    5,250
    Joined:
    Jan 1, 2007
    Check the Digidesign User Conference under Support. Very helpful in these situations. I have a Digi 002R but have no idea what you're talking about. I'm still well toward the middle of the learning curve...uh, well, maybe make that well toward the bottom. Sorry I can't help more.


    Tom
     
  3. testing1two

    testing1two Gold Supporting Member

    Messages:
    1,741
    Joined:
    Mar 26, 2008
    Location:
    Southern California
    Well, after searching the Digi answer base and a few other forums, I stumbled upon the correct search terms. For anyone dying to know how to reset a Digi 002, here's how it works:
    How can I reset my 002 firmware to factory default settings?

    To restore defaults:
    1) Power 002 off.
    2) Hold down the following 3 buttons: ESC+Display+Rec
    3) Keep holding down these buttons
    4) Power 002 on. Keep buttons depressed until "Restoring Defaults..." appears onscreen
    5) Allow Restoring Defaults... to run through its whole natural cycle.. if it completes successfully, 002 will be left in Standby mode.
    Note: This process will delete any standalone mixer snapshots.

    http://www.digidesign.com/index.cfm?navid=54&langid=61&itemid=17547
     

Share This Page