Fender Concert(Rivera) reverb issue....

Discussion in 'Amps and Cabs' started by Chad-Chicago, Jan 18, 2015.

  1. Chad-Chicago

    Chad-Chicago Member

    Messages:
    191
    Joined:
    Jan 13, 2011
    Howdy...When I engage my reverb, I just get a hum, no reverb. Power cycle the amp and it works for a bit. I'm guessing it's a tube issue?? Any recommendations would be appreciated.

    Thx
     
  2. Noise Under The Floor

    Noise Under The Floor Supporting Member

    Messages:
    8,607
    Joined:
    Feb 10, 2010
    Location:
    "In the drag of this atmosphere" (Maryland)
    Most likely the pre amp tube for the reverb, but also check the cable connections. There should be 2 thin cables/wires that run between the reverb tank and the amp. Make sure those are connected properly or not broken. Probably has a 1/4" jack on one end that plugs into the amp and then 2 RCA connectors on the opposite end plugged into the reverb tank. If it works for a bit though as you say, I'd guess its a tube issue though.
     

Share This Page