GigRig HumDinger Isolater/Buffer Pedal

Not open for further replies.


Silver Supporting Member
TheGigRig HumDinger Isolater buffer pedal, excellent condition. Eliminates ground loops when using multiple amps and can also drive long cable runs.
Must be powered by 9V DC Power Supply (not included).

If you use 2 amps, mains powered effects, or need to drive long cables, the HumDinger is essential.

The Humdinger was designed to eliminate earth loops in audio equipment by isolating the second output with a high quality audio transformer.

" The Main output is buffered using our custom designed 1:1 class A buffer design guaranteed not to mess with your tone.
" The Isolated output uses a high quality audio transformer to the best signal possible.
" The isolated output also features a PHASE switch, so you can get rid of any phase problems between two amplifiers.
" Both outputs will drive long lengths of cable so you don't need to worry about the distance between your pedal board and your amp.
" It's impossibly small and will fit on even the smallest of pedal boards.

Earth loops are a common complaint. As soon as the ground on your gear has more than one main route to earth, you have the potential for an earth loop.
The best and safest way to get rid of an earth loop is to isolate the ground that is causing the hum.

Using the HumDinger to get rid of earth loops is easy. If you use 2 amps all you need to do is stick the HumDinger at the end of your effects chain. Your main (buffered) output goes to one amp, and the isolated output goes to the other. Your earth is consistent through the main output but isolated through the isolated output.

Using a mains powered effects pedal, simply place the HumDinger in the chain after the mains powered effect.

The Mains powered effect is your main ground and the ground from the amp is isolated.
Last edited:
Not open for further replies.

Trending Topics

Top Bottom