Logidy Epsi help

Discussion in 'Digital & Modeling Gear' started by chrisjnyc, Mar 17, 2015.

  1. chrisjnyc

    chrisjnyc Member

    Messages:
    4,406
    Joined:
    Jun 17, 2009
    I am a little new to the Epsi. I was able to upgrade the firmware to 1.0C. Every time I try to load a 24 bit IR file (Wav). It gives me an error 3 message. Anyone seen this? Also, anyone with some (Epsi) working cab IR's, can I get a couple to test with?
     
  2. Jay Mitchell

    Jay Mitchell Member

    Messages:
    4,827
    Joined:
    Oct 13, 2007
    That's because the EPSI only accepts 16-bit, 44.1kHz IRs.
     
  3. moonblack

    moonblack Member

    Messages:
    222
    Joined:
    May 8, 2007
    actually epsi accept both 16 and 24bit. maybe wrong sample rate 48khz.
     
  4. chrisjnyc

    chrisjnyc Member

    Messages:
    4,406
    Joined:
    Jun 17, 2009
    How can I check the sample rate? Anyone have some 44.1Khz IR's?
     
  5. slugworth

    slugworth Supporting Member

    Messages:
    2,218
    Joined:
    Sep 1, 2011
    Location:
    ConUSA
    The V3 Mix libraries at Ownhammer are just $5. Tons to choose from, so pick your poison. Think of a speaker you like in real life, and they probably have it.

    When you unzip an Ownhammer file, go to the \Wav folder, then you'll see them divided by sample rate and mono/stereo.
     
  6. swinginguitar

    swinginguitar Member

    Messages:
    887
    Joined:
    Mar 25, 2010
    24 bit files work for me
     
  7. swinginguitar

    swinginguitar Member

    Messages:
    887
    Joined:
    Mar 25, 2010
    also - do you have the stock IRs that shipped with the EPSi? Those *have* to work...

    I suspect you may have non 44.1k files.

    You can open the wave file in a DAW or audio editor and check the sample rate
     

Share This Page