1. snoopy1@isoc.ne

    snoopy1@isoc.ne Silver Supporting Member

    Messages:
    502
    Joined:
    Oct 28, 2004
    Location:
    Cincinnati Ohio
    I have a Line 6 pod XT Live with no send and return just going into the input on the amp. is there a box or something that I can use to loop my XTL into my amp send and return HELP. Thanks Mike
     
  2. aleclee

    aleclee TGP Tech Wrangler Staff Member

    Messages:
    12,215
    Joined:
    Jan 4, 2002
    Location:
    5868 ft above sea level
    I run mine in the loop

    Guitar -> Amp input -> (FX send) XTL -> (FX return) -> Amp's power section

    Depending on what you're looking to do with the XTL (with this setup I use it for delay/reverb/modulation/volume/boost) it works fine. The wah doesn't sound so good in the loop and some of the compressors breathe a bit too much, though.
     
  3. snoopy1@isoc.ne

    snoopy1@isoc.ne Silver Supporting Member

    Messages:
    502
    Joined:
    Oct 28, 2004
    Location:
    Cincinnati Ohio
    Thanks for the fast reply but the pod dosent have a loop goes right into the amp input is there somthing I can buy to do it in the send and return?
     
  4. aleclee

    aleclee TGP Tech Wrangler Staff Member

    Messages:
    12,215
    Joined:
    Jan 4, 2002
    Location:
    5868 ft above sea level
    Allow me to clarify

    Guitar -> Amp input -> (FX send to XTL input) XTL -> (XTL output to FX return) -> Amp's power section
     
  5. snoopy1@isoc.ne

    snoopy1@isoc.ne Silver Supporting Member

    Messages:
    502
    Joined:
    Oct 28, 2004
    Location:
    Cincinnati Ohio
    I called GC the set up is differant than the pro they fixed me up thanks everyone
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice