M13 and saving a scene?

Discussion in 'Digital & Modeling Gear' started by Melodic Dreamer, Dec 23, 2009.

  1. Melodic Dreamer

    Melodic Dreamer Member

    Messages:
    5,994
    Joined:
    Aug 15, 2005
    Hey guys, I left my manual at a friends house, so I need some help.

    I set the First scene up, I think it was called scratch pad. I had all 12 effects made/created. Took it to the church to play with it. I plugged it up and my effects were still there. I played for a little while and I then decided to switch scenes. After going through different effects I tried to go to the first scene again. when I came back to the first scene, it had went back to the factory settings. It erased all of my settings. I worked so hard :knitting
    :cry:

    Anyway, How do I create a scene and save it?
     
  2. guitarman_1

    guitarman_1 Silver Supporting Member

    Messages:
    1,627
    Joined:
    Dec 18, 2002
    Location:
    Central, Fl
    Make sure your M13 is programed to auto save. go into the menu, and check where its set.I think that should it.
     
  3. Geno_xl

    Geno_xl Member

    Messages:
    109
    Joined:
    Dec 14, 2009
    probably a stupid question but did you look in the same folder you used when creating your scene.
     
  4. Melodic Dreamer

    Melodic Dreamer Member

    Messages:
    5,994
    Joined:
    Aug 15, 2005
    same folder?

    I went to the same place I made my patches if that's what you mean. First screen bottom of the three. I think the name was scratch pad. I'll try what you guys have suggested. I just haven't had time to plug it back up.
     

Share This Page