Separate names with a comma.
Discussion in 'Amps and Cabs' started by rockstah, Nov 5, 2005.
shy one 56k resistor and reconfigured my diode placement
Make me one Let me know how it turns out.
Just ordered my trannys!
MAR100-C - 8H 200mA -- 100 watt
Georges( metroamp.com) dual PT (495-500V with the high voltage taps. And 395-400 with the low voltage taps.
cant wait to start!
Why are you using a 200ma choke?
what should i use?
paul at mm recommeneded it? *scratches head *
Red boards sound better.
I was just curious why you chose it.
what would you recommened?
The Mercury like you ordered.
When I saw your post I thought you
just bought a random choke,
but with the Mercury I understand
why its larger.
is my underatanding correct here? the smaller the 5h or even 3.3 would lend to break up earlier than 8h choke i have chosen?
I was referring to the current handling, not hry's.
Its not a matter of breakup, its a matter
You could use a 3hry choke with no problems,
and even a 20hry choke if you wanted to.
The choke in a Plexi power supply is only
filtering the low level circuitry (preamp+screen supplies).
Not a big demand here.
I did recomend you run with the Mercury trannys,
and I'm glad to see you did.
Your set is a clone of exactly what you're wanting to build.
thanks much - you still didnt say what you would recommend choke wise
and i didnt go with tranny(s) i went with OT from mercury the the PT is metroamp.com!
hard to see but i have the two 56k 2w in parallel with the 33uf caps on cap board (one on each33uf cap )
hows this lookin?